I have not done much of anything to the Alfa since changing the clutch, it has been an excellent car so far.
That said, I have been preparing for the Megasquirt2/Extra installation. At first I had decided to make a "plug-n-play" installation built around another Bosch 35 pin ECU. But upon further reflection, I've decided to remove the factory engine harness and build my own own replacement harness.
I pulled the engine harness from an early 90s Audi 90, so that gives me connectors for the injectors and coolant temp, I have a GM IAT pig tail that I will add to the modified Audi harness.
I found some 18 gauge/3 conductor shielded wire at Intertex which I will use for the distributor to MS and MS to coil wiring.
With any luck I'll have MS in and running within the next couple of weeks.. and then I get to start working on the Turbo setup.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment